To use this Ring & Bracelet/Anklets sizer correctly you must un-check the "fit to page" option when you print. If you've opened this adobe then select "Actual Size" before printing. After you've printed this page, verify the print was correct using the test bars below
Measure one of the bars in this box using a ruler. This bar must measure to be exactly 1 inch (or 3 cm)long. If the bar on the left is not exactly 1 inch (or 3 cm) long, you have not printed this chart correctly.
There are two ways of finding your ring size with this sheet:
Place a ring that fits comfortably over the circles to measure the inside diameter. Make sure that the circle is completely visible inside the ring.
Cut out the ring sizer and cut the slit out that's marked with an arrow. For best results use a hobby knife.Once you wrap the ring sizer around your finger, insert the pointed end into the slit, tightenthe band slowly until it fits comfortably around your finger. Now check the size that is visible from the slit; if it's hard to read then mark it with a pen or pencil to read once you